ART Pro Channel II - Professional Tube Microphone Pre-Amplifier / Compressor / EQ
The ART Pro Channel IITM uses second-generation discrete Class-A microphone preamp to provide clean quiet gain while maintaining incredible transparency. A powerful dynamics processor subtly controls transients and noise of the most demanding sources.
The ART Pro Channel IITM 's semi-parametric EQ offers wide tune-ability and can be patched before OR after the dynamics processor. Separate rear-mounted insert points allow patching in external signal processing gear immediately after the Mic preamp and before the EQ and dynamics processor. Both analog and LED meters provide a detailed indication of audio levels.
Fully Featured discrete class "A" Tube Microphone Preamplifier
1/4" High Z input on the front panel
Selectable plate Voltage
Smooth musical sounding Optical Compressor
Separate Attack and Release controls
Auto/Manual Attack/Release switch
Large VU and LED meters
Multi section clip monitor LED
Selectable Source switches for VU signal monitoring of any section of the unit
Two insert loops
+4/-10 dB switch for optimal signal output levels
Toroidal power transformer for low noise
Mic: 150 to 3.4K Ohms, variable
Instrument: 2.5M Ohms
Preamp Insert: .5K Ohms
Balanced Output: 600 Ohms balanced
Unbalanced Output: 300 Ohms
Insert Outputs: 300 Ohms
Analog In to Analog Out: 12Hz to 100KHz +0, -1dB
THD @ 1 KHz: <0.15% typical
THD @ to to 20 KHz: <0.033% typical
Equivalent Input Noise
Mic/Line: -128dBu, Input shortened, Max gain, "A" weighted
Instrument: -109 dBu, Input shortened, Max gain, "A" weighted
Maximum Input Level
Mic: +18dBu balanced
Instrument: +15 dBu
Mic: 70dB (XLR to balanced output)
Instrument: 64 dB (1/4" to balanced output
Maximum Output Level
Balanced: +24 dBu
Unbalanced: +20 dBu
Output Level At Meter 0 VU: +4 dBu/-10dBV
Microphone Gain: 0 dB to +56 dB
Instrument Gain: +3 dB to +50 dB
Low Cut Filter: 0 - 250 Hz, 1-pole, 6 dB/Octave
Boost/Cut: +/- 12 dB on each band
Low Freq. Tuning: 40 / 120 Hz Selectable
MID 1 Freq. Tuning: 20 Hz to 2 KHz continuously variable
MID 2 Freq. Tuning: 200 Hz to 20 KHz continuously variable
High Freq. Tuning: 6 KHz / 18 KHz Selectable
Compressor / Limiter
Attack Time: 250 uSec. to 100 mSec.
Release Time: 00 mSec to 3 Sec.
Compression Ratio: 2:1 to 30:1
Dimensions (H x W x D - in): 3.5 x 19.0 x 9.2
Dimensions (cm): 8.9 x 48.3 x 23.3
Weight (lbs/kg): 11/5
Power Requirements: USA - 105 to 125 VAC/ 60 Hz
Export units configured for country of destination.
Note: 0 dBu = 0.775 VRMS, 0 dBV = 1 VRMS
Equipment available to buy from this site is for professional use only. Please note in certain countries some products listed may not be available from A.C. Entertainment Technologies Ltd.
E&OE. Information is subject to change without notice. The rights and ownership of all trademarks are recognised.