ART Deejaypre Two - Phono/Line Pre-Amplifier
The DJ PRE II (formerly named the "Phono MicroPRE") acts as an interface between your turntable and your audio recording / playback system. The analog input capacitance can be switched between 100pF and 200pF to optimize your phono cartridge response. A switchable low cut filter removes turntable rumble while leaving the audio pristine. The front gain trim control and signal/clip LED allow you to optimize the preamp's gain for a wide range of input sources. The built-in low noise phono preamp circuitry is highly accurate and precisely conforms to the RIAA standard. The line output jacks are low impedance and can be used with any sound card.
Housed in an all aluminum black anodized case, the DJ PRE II can be powered by a wide variety of external supplies. If you need to amplify and EQ your vinyl records to interface with your audio workstation, sound card, home stereo system or main monitor system, the DJ PRE II gives you flawless audio reproduction in a rugged and reliable package.
Signal To Noise Ratio > 90dB below clipping
Frequency Bands FILTER TYPE: Switchable, Low Cut, -3dB @22Hz
Maximum Gain 45dB @1KHz
Input Impedance 47k Ohms in parallel with either 100pF or 200pF
Maximum Input Level 40mVrms @1KHz
Maximum Output Level +6dBu (1.4Vrms)
Input Connectors RCA
Output Connectors RCA
Total Harmonic Distortion .01% Typical @1KHz
Frequency Response 10Hz -50KHz, +/-.5dB
Power 7-12V DC or 9-12V AC @150mA
Dimensions 1.75"H x 4.2"W x 3.5"D
Weight 1.25 lbs (.57kg)
Equipment available to buy from this site is for professional use only. Please note in certain countries some products listed may not be available from A.C. Entertainment Technologies Ltd.
E&OE. Information is subject to change without notice. The rights and ownership of all trademarks are recognised.